English (en-GB)
German (Germany)
English (en-GB)

stute.x1A USB audio interface tips

Gain

Headphone: 70%

Inputs L&R: 75%

Mix: Draw 100%

Output: 0% 


Switch front

Input 1&2 Hi-Z "off"



Notes

- ASIO driver model recommended, min. 1024 samples

- Enable "48V" only for measurements with microphone

- Input 2 = Channel right

- Set the bit resolution in the ASIO panel to 2x24bit for Input & Output



Gain

Headphone: 70%

Line Inputs L&R: 50%

Output: 0%


Switch front:

All switches disabled 


Notes

- ASIO driver model recommended,  1024 samples recommended

- Enable "48V" only for measurements with microphone

- Input 2 = Channel right



In case of a calibration error "Signal to low":

  1. Check the cable connection between x1S<->audio interface
  2. Increase the audio interface headphone volume.
  3. Increase the audio interface input gain for both inputs 
  4. Decrease the sample rate
  5. Use ASIO driver instead WDM  (stute.x1A Setup audio interface) or vice versa.
  6. Disable all sound enhancements of the audio interface

Connection stute.x1S - audio interface 

Connect the x1S "Input" with the "Headphones" output of the audio interface (Cinch cable, Red=Right channel). Connect the x1S "Output" with the audio interface "Input 01/L" and "02/R".